Outdoor kitchens in Denton
Denton, the Denton County seat, was founded in 1857 to be exactly that, and Census estimates show it growing from about 139,900 residents in 2020 to about 169,400 in 2025. It has some of the oldest houses we work on in the Metroplex, wood-sided bungalows and cottages near the Square and the two university campuses, alongside subdivisions finished in the last few years. A 90-year-old wood-sided house and a 10-year-old vinyl-sided one need different answers, and Denton's permit and historic rules are stricter than most.
Backyards in Denton range from the shaded lots in the old neighborhoods near the Square and the university campuses, to newer subdivisions with pools and HOAs, to acreage on the edge of the city where a pavilion can sit wherever the view is best. The rules are the same city-wide, but the design isn't: an outdoor kitchen behind a 1920s bungalow should look like it's been there all along, and one in a new subdivision has to clear the HOA as well as the city.
Who builds outdoor kitchens in Denton?
Snow Roofing & Exteriors does. Here are the facts you can check before you call anyone:
- 75 years as a family roofing and exterior business, and 30 years in the trade for owner Blake Snow.
- 5.0 stars on Google at all three offices: Bridgeport, Decatur and Rhome.
- Snow Roofing & Exteriors is BBB A+ rated, fully insured, with references available on request.
- Our own crews, who frame, roof, side, trim and finish outdoor kitchens and covers from start to finish.
- One company for the whole outside of the house: roofs, gutters, siding, windows, soffit and fascia, paint, and outdoor living.
- A workmanship warranty from 10 years up to lifetime, depending on the job, in writing.
Four ways to put a roof over an outdoor kitchen
Most Denton outdoor kitchens end up as one of these. Which one fits depends on the back of the house, where the sun sets, how close the pool or the fence line is, and what the city allows on your lot.
| Layout | Good for | What to watch |
|---|---|---|
| Attached cover, tied into the house roof | Short walk from the kitchen door, one continuous roofline | The tie-in is the most common leak spot on any patio roof, and attaching can change how the city treats the structure |
| Freestanding pavilion | Putting the grill where the view, the pool or the shade is best | Footings, wind bracing and setbacks from the property lines |
| Cover over an existing island | Owners who already have counters and a grill out in the sun | Whether the island can stay where it is, and how smoke will clear |
| Kitchen built into a pool house | Big backyards, entertaining, a bath and storage under one roof | Plumbing to the sewer, pool setbacks and, for enclosed buildings, wall material rules |
We plan the cover and the kitchen together, so the posts land where the counters need them, the vent hood has a clear path, and the roof drains away from the cooking area and the pool deck.
City of Denton permits for patio covers and outdoor kitchens
Denton has its own patio cover page, and it's specific:
- Permits are required. A patio cover is a one-story structure that can be attached to the house or detached, and it can only be used for outdoor living, not as a carport, garage, storage room or habitable room.
- What goes in: the residential application, a site plan showing every structure on the lot and the setbacks from the cover to the property lines, an elevation with height and width, framing plans including how it attaches, foundation plans, and an electrical plan if there are outlets or lights.
- Inspections: pier or foundation, electrical rough-in if there's wiring, and a building final. Contractors schedule inspections through the city's eTRAKiT portal.
- Fees are based on square footage, with more if there's electrical or plumbing work. Those are city fees, not our price.
A detached kitchen pavilion also falls under the city's accessory structure rules, which list detached patio covers, gazebos, cabanas, pergolas and arbors. Those rules say an accessory structure must be architecturally compatible with the house and can't go in the front or side yard, and the city's arbor and pergola page adds that accessory structures stay 3 feet from all property lines. The Denton Development Code also keeps accessory structures out of easements and counts them, with the house, toward the zoning district's maximum building coverage. The city's submittal checklist says foundation designs over 400 square feet need a Texas engineer's seal. Gas, electrical and plumbing work is done by the right trade under its own permit. We confirm the details with Development Services at (940) 349-8600 when we file.
Building an outdoor kitchen in a Denton historic district
If your house is in one of Denton's three local historic districts, Oak-Hickory, the West Oak Area or Bell Avenue, or it's a designated landmark, the city's Certificate of Appropriateness rules cover exterior alterations, additions and new construction, not only work on the house itself. Additions and new construction go to the Historic Landmark Commission, which generally meets on the second Monday of each month, and the certificate comes before the building permit. We draw an outdoor kitchen to fit the house's period and materials, photograph the property for the packet, and build the commission's calendar into the schedule.
Matching an old house or a new one
Behind an older Denton bungalow or cottage, the cover should borrow from the house: the same roof pitch, exposed rafter tails, painted wood posts and a ceiling that looks like a porch. On a newer brick house, stone-wrapped columns and a standing seam roof in a color pulled from the shingles usually look best. Denton's mature trees matter either way. A metal roof sheds leaves and handles the occasional falling limb better than most, and we keep the grill and hood clear of overhanging branches.
The roof is what has to last
An outdoor kitchen cover is a real roof that happens to have no walls. It gets the same hail and wind as your house, plus heat from the grill underneath. What we put on it:
- Standing seam metal, which we form on our own roll formers in 24 or 26 gauge. It handles the low pitch most covers have, sheds oak leaves, and looks right next to brick and stone. Metal lead time is typically 1 to 2 weeks. See standing seam.
- Shingles matched to the house, including impact-rated shingles, where the cover has enough pitch.
- Tile, slate or Enviroshake tie-ins on homes with those roofs. We match the main roof when the pitch and framing allow, or pair it with standing seam in a color pulled from the house. See outdoor kitchen roofs that tie into tile or slate.
- Gutters and downspouts sized so a summer downpour doesn't sheet onto the counters or wash out a flower bed. See gutters.
Where the new roof meets the house, we flash it into the wall or under the existing roofing. That joint should never depend on caulk.
Smoke, heat, gas and power
A covered grill needs somewhere for the smoke and heat to go. We plan the ceiling height, the vent hood and the clearances to the grill maker's instructions before framing starts, and we keep combustible trim away from the heat. Gas lines, electrical circuits for lights, fans and outlets, and any sink plumbing are done by the right trade under their own permits, and we schedule that rough-in so nothing has to be torn back open later. Natural gas or propane, a built-in refrigerator, an ice maker or a pizza oven all change what goes into the plan, so we ask about appliances first.
Denton's hail and wind record
NOAA's Storm Events Database lists 40 reports of hail 1.75 inches (golf-ball size) or larger within about 10 miles of Denton from 2016 through the September 2026 update. The ones closest to town:
- April 11, 2016: the big one for Denton. NOAA lists 4-inch hail in Denton under two miles from the center of the city, 2.75-inch hail near Mayhill and 2.5-inch hail about half a mile from the center of the city, plus three more golf-ball-size reports around town the same night.
- May 24, 2020: 2-inch hail at two spots in Denton, both under two miles from the center of the city.
- March 26, 2017: 4.25-inch hail near Corinth, about five miles south.
- May 10, 2021: 4-inch hail near Ponder, on the west edge of that ten-mile circle.
- June 15, 2023: 5.9-inch hail near Sanger, right at the north edge of the circle, the largest hail NOAA lists anywhere in Denton County from 2016 through the September 2026 update.
- Smaller hail keeps coming: 1.25-inch hail about two miles from the center of the city on September 21, 2023, and 1-inch hail in Denton on June 2, 2024 and May 6, 2025.
That's why an outdoor kitchen cover gets real roofing, underlayment and flashing, not a thin panel screwed to a frame.
Tornadoes and straight-line wind in Denton
NOAA's event narratives show how wind does its damage here:
- April 30, 2019, EF-1 tornado. It formed on the east side of the Texas Woman's University campus, uprooted large trees along the TWU golf course, crossed University Drive and ran northeast through heavily wooded neighborhoods in northeast Denton before ending near Sherman Drive (FM 428) and Hartlee Field Road. Most of the 2.9-mile track was EF-0 damage (60 to 75 mph), with spots of 85 to 90 mph. NOAA notes that large trees falling on homes and vehicles caused much of the property damage.
- April 17, 2019: the Denton airport measured a 74 mph gust, and metal roofs were torn off three buildings at UNT's Rafes Urban Astronomy Center next to it.
- May 28, 2024: Guinn Hall at TWU recorded an 83 mph gust, and trees came down around downtown Denton.
- June 3, 2025: part of a warehouse roof and wall collapsed near Highway 380 and Western Boulevard.
- September 5, 2025: Denton Enterprise Airport recorded a 75 mph gust, damaging a hangar and several small planes. On September 21, 2025, a 68 mph gust was measured at TWU.
In Denton's older, tree-lined neighborhoods, a storm inspection isn't only about hail. We look for limb strikes, punctured decking, cracked rafters and torn flashing where branches came down, and we photograph the inside of the attic where something hit.
How an outdoor kitchen job runs with us
- Site visit. We look at the back of the house, the roofline, the yard and the pool, and talk about how you cook and entertain.
- Design. We can bring in an architect to spec a new build, or build to plans you already have.
- Written scope. Structure, roof material and color, gutters, appliances, finishes and every flashing detail, with no surprises later.
- Approvals. Your HOA's approval if you have one, then the permit with the City of Denton. We prepare the drawings and the site plan.
- Build. Our own crews build it from start to finish. The trades for gas, power and plumbing are scheduled around the framing.
- Inspections and walk-through. We call for the inspections, walk the finished kitchen with you, and give you the workmanship warranty in writing.
More for Denton homeowners
Planning the whole backyard? See pool houses in Denton and our pergolas and patio covers. For the house itself: standing seam in Denton, tile roofing, siding, exterior painting and storm damage.
We're certified with GAF, CertainTeed, Owens Corning, Atlas, Johns Manville, Carlisle, Tropical Roofing Products, Mule-Hide and Enviroshake, and many other roof manufacturers.
Residential warranty: a workmanship warranty from 10 years up to lifetime, depending on the job, with manufacturer warranties up to lifetime. Manufacturer coverage depends on the product and brand, and on the project qualifying for that manufacturer's program. We put the exact warranty for your roof in writing.
Certified, with 30 years installing every major roofing brand, a family roofing business going back 75 years, and over $80 million in completed roofing projects. 5.0 stars on Google at all three of our offices.
Request a free inspection or call (817) 733-9228. Small repairs are welcome too.
