How much does a shingle roof replacement cost in Denton? I get that question on almost every estimate between Krum and Lake Dallas, and the honest answer is that it depends on a handful of things you can see on your own roof. I’m going to walk through each one in plain words, so when a bid lands on your table you’ll know exactly what you’re paying for.
I’m Blake Snow. I’ve been roofing for 30 years, I’m the third generation in a family business that goes back 75 years, and our Decatur office sits just west of Denton on US 380. We replace shingle roofs all over Denton County.
You won’t find a dollar-per-square number here. That’s on purpose. I’d rather show you what moves the price, then measure your roof and put a real figure in writing.
The short answer
- Size, pitch and stories do most of the work on the price.
- Tear-off and decking are the two big unknowns until we’re on the roof.
- Roof shape matters: a hip roof has many more valleys than a gable roof.
- The shingle you pick matters: Class 3 is our minimum, Class 4 costs more, designer lines more again.
- Denton has its own permit rules, and a good bid already includes what the city inspects.
Shingle roof replacement cost in Denton: what sets your price
1. Roof size, measured in squares
Roofs are measured in squares. One square is 100 square feet of roof, not floor space. A one-story house with deep overhangs and a covered patio can have more roof than a two-story with a smaller footprint. Shingles, underlayment and labor all scale with the squares, so this is the biggest line on any estimate. We measure every plane, including porches, patio covers and the garage.
2. Pitch
Pitch is how steep the roof is, written as rise over run. Most houses I roof run between 6/12 and 8/12, which the crew can walk and work at a normal pace. Steeper than that, the work slows down, more safety setup goes up, and the price goes up with it.
3. Stories and access
On most Denton houses access is easy: we back a trailer up to the house and the old shingles go straight into it. What makes a job harder is pitch and the number of stories. A steep two-story roof takes more time to strip and load safely than a single-story ranch.
4. Tear-off and layers
Most of our jobs are tear-offs, and I tear shingle roofs off down to the deck so we can see what’s under them. If someone shingled over an old roof years ago, there are two layers to strip and haul instead of one. Under the International Residential Code (section R908.3.1.1), a roof that already has two layers can’t be covered again; it has to come off.
5. Decking
Nobody knows how much decking is bad until the shingles are off. Soft or rotted wood around old leaks, valleys and chimneys has to be replaced before anything goes back down. In Denton, replacing any decking also means a Residential Alteration Permit, and the city checks deck thickness at the final inspection. A good bid tells you up front how decking will be handled and priced, so there are no surprises.
6. Valleys, trim and penetrations
A cut-up hip roof has many more valleys and hips than a simple gable, and each one adds cutting, flashing and labor. Trim is generally fascia and drip edge. Then there are penetrations: bathroom plumbing jacks, dryer vents, HVAC stacks and fireplaces. Every one has to be flashed. A house with three baths, two HVAC systems and a chimney has a lot more of that work than a small ranch.

7. Which shingle you choose
- Class 3 impact-resistant is the minimum I put on any house. See our Class 3 shingles page.
- Class 4 impact-resistant shingles carry the top UL 2218 hail rating and cost more. Many Texas insurers give a discount for them; our Texas impact-resistant roof insurance discount guide explains how to ask. See Class 4 shingles in Denton.
- Designer and luxury lines with a slate or shake look are heavier and cost more again. See designer and luxury shingles.
8. Ventilation
Attic ventilation is usually included in our jobs, because a roof needs proper ventilation to last. Heat trapped in a Texas attic cooks shingles from underneath. If one bid includes balanced intake and exhaust and another doesn’t mention it, they aren’t the same roof.
What Denton’s permit means for your bid
Since June 1, 2022, the City of Denton requires a roof permit for every residential re-roof, issued before tear-off starts and posted where it can be seen from the street. The final inspection includes the attic. The city’s list includes:
- Drip edge on all asphalt shingle roofs
- Replacing damaged, rusted or worn roof vents and flashing
- Exhaust vents with dampers and screens; dryer vents with dampers and no screen
- A plan review first if you’re changing roofing materials
That’s why a low bid that skips drip edge or reuses rusty vents isn’t a real comparison. We check every job with the city and handle the permit when one is required. If you’re in Corinth, Krum or Sanger, the rules are set by that city, so we check there too.
Hail, insurance and timing
Denton gets real hail. NOAA’s Storm Events Database lists 1.25-inch hail west-northwest of Denton on September 21, 2023 (NCEI 1142351), 1.5-inch hail near Loop 288 and Hwy 77 on June 2, 2024 (NCEI 1195069), and 5.9-inch hail near Sanger on June 15, 2023 (NCEI 1109306).
If hail or wind damaged your roof, insurance may pay for part or all of the replacement after your deductible. In Texas you generally have 1 year from the date of loss to file a claim, but check your policy. On insurance jobs, emergency tarping is included in the claim. Our Denton storm damage page and our post on hail damage to Denton roofs walk through the claim step by step.
How to compare two shingle bids
- Measured squares. Are they close? A big gap means someone missed the porch or garage.
- Tear-off and layers. Down to the deck? How many layers?
- Decking. How is bad wood priced?
- Shingle line and class. Class 3, Class 4 or designer, named by brand and line?
- Flashing, vents and drip edge. Replaced, or reused?
- Ventilation. Included, or left out?
- Permit. Who pulls it?
- Warranty in writing. Ours runs from 10 years up to lifetime, depending on the job.
If you need gutters or soffit and fascia anyway, one crew can do it with the roof, on one estimate. And if you’re thinking about a metal roof in Denton instead, we’ll price both side by side.
Get a real number for your Denton roof
The only way to know what your roof costs is to measure it. An inspection usually takes 15 to 45 minutes, and you don’t need to be home unless there’s a leak inside. You get a free, itemized written estimate and a digital photo report of what we found.
We’re certified with GAF, CertainTeed, Owens Corning, Atlas, Johns Manville, Carlisle, Tropical Roofing Products, Mule-Hide and Enviroshake, and many other roof manufacturers. We’re fully insured, BBB A+ rated, with references available on request, and we have 5.0 stars on Google at all three offices: Bridgeport, Decatur and Rhome.
Request your free estimate or call (817) 733-9228. You can also use the estimate form below.

