Ranch and farm barns around Montague County's biggest town
Bowie is the largest town in Montague County. TSHA says it was named for Alamo defender Jim Bowie when residents applied for a post office in 1882, and Census estimates show it at 5,445 residents in the 2020 base and about 6,113 in 2025. Around town it's ranch and farm country: hay barns and loafing sheds on U.S. 287 and State Highway 59, horse barns near Lake Amon G. Carter, and shops and barndominiums on newer acreage tracts. Many of the older barns wear thin galvanized panels that have been patched for decades.
Our Bridgeport office is about 31 road miles (roughly 43 minutes) away, down State Highway 101 and U.S. 287. See also our guide to ag building roofs in Montague County.
Which metal goes on which building
A barn roof isn't one product. What goes on a hay barn in Bowie isn't always what belongs on a horse barn or a shop you can see from the back porch. Here's how we match the panel to the building:
| Building | What we usually recommend | Why |
|---|---|---|
| Hay barn, equipment barn, loafing shed | R-panel or PBR, 24 or 26 gauge | Strong ribs that span open purlins, quick to install, easy to repair a panel at a time |
| Pole barn or post-frame building | R-panel or PBR, with closures and trim made for the panel | The screw pattern at the eaves, rakes and ridge is what holds it down in a storm |
| Horse barn, stable or covered arena | R-panel, PBR or standing seam, with ventilation and condensation planned | Animals add moisture to the air, and bare steel sweats over it |
| Show barn, or a barn in full view of the house | Standing seam | Hidden fasteners, clean lines and no exposed screws to re-tighten later |
| Barndominium or barn with living space | Standing seam or R-panel over a planned insulation and vapor layer | See barndominium, shop and ag roofs |
| Sheds, carports, boat and RV covers | Corrugated, R-panel or PBR | Matches older buildings and keeps small jobs simple |
We form standing seam and R-panel on our own roll formers in 24 or 26 gauge, and we also offer corrugated and PBR panels. Metal lead time is typically 1 to 2 weeks. We don't post prices, because building size, framing condition, tear-off and trim change the number a lot. You get a written price for your building.
Re-screw, re-panel or re-roof?
Most old barn roofs don't have to come off. We walk the roof where it's safe, fly a drone where it isn't, look at the purlins from inside, and show you the photos behind our call:
- Re-screw: the panels are sound, but rubber washers have cracked in the sun or screws have backed out. New fasteners, one size up where the holes have worn oval, can add years to a roof that's otherwise fine.
- Partial re-panel: some panels are rusted through, punctured by hail or bent by wind, usually along the eaves, the rakes or an old lean-to. We replace those panels and fix the trim and closures around them.
- Full re-roof: rust is widespread, the old panels are too thin to hold a screw, or the barn is being enclosed or finished for living space and needs an insulation and vapor plan. See metal roof repair and restoration.
Whichever it is, we check the framing first. A new roof on rotted or undersized purlins is money spent twice.
Tornadoes and barn damage around Lake Amon G. Carter
NOAA's storm reports around Bowie read like a list of barn damage. NOAA's Storm Events Database records:
- March 21, 2022, EF-1 tornado: it began on the north side of Lake Amon G. Carter along Hanging Tree Road, about five miles from Bowie, and damaged multiple small barns and farm outbuildings. Northeast of the lake it lifted the roof off a farm outbuilding and collapsed several walls. NOAA estimates peak winds at 95 mph.
- April 19, 2025, EF-0 tornado: it formed on the east shore of the lake near the Bowie Country Club, damaged fencing and outbuildings, then hit horse barns and other outbuildings near FM 1125. The same storm's straight-line winds partly peeled up the roof of at least one barn in central Montague County, about four miles from town.
- April 20, 2025: near Smyrna, about six miles away, NOAA notes roof damage to a well-built horse barn.
- May 25, 2024: a long-track tornado began near Roth and Body roads about five miles southeast of Bowie, damaging trees and isolated outbuildings before it moved east across southern Montague County.
Hail: NOAA lists 14 reports of hail 1.75 inches (golf-ball size) or larger within about 10 miles of Bowie from 2016 through the September 2026 update, including 3-inch hail at Bowie on April 11, 2016, under a mile from the center of town, 2-inch hail at Bowie on May 22, 2020, 2.5-inch hail west of town on May 9, 2024, and 2-inch hail near Fruitland on May 19, 2025. Montague County as a whole logged 25 such reports, up to 4.5 inches.
What wind does to a barn roof
A house is closed on all sides. Most barns aren't. Wind blowing into an open bay or a big door pushes up on the underside of the roof while it pulls on the top, so a barn roof takes load from both sides at once. That's why the failures we see follow a pattern:
- The edges go first. Eaves, rakes and the ridge carry the most uplift. If a panel is going to peel, it usually starts there, then the wind gets under the next one.
- Screws loosen before they let go. Years of heat and cold work exposed fasteners loose. A loose screw leaks first, then the panel starts to lift.
- Trim and closures matter. Missing foam closures and loose rake trim let wind and wasps in and give a gust something to grab.
- Old lean-tos are weak links. Additions framed lighter than the main barn, or lapped onto it badly, are where many barn roofs start to fail.
When we roof or repair a barn, the fastener spacing at the edges, the trim attachment and the condition of the purlins get the most attention, because that's what keeps the roof on the building.
Bowie permits, and barns on county land
Inside the city limits, Bowie's permit fee schedule lists a residential roofing permit at $45 and a residential accessory structure permit at $35, with inspections at $25 each. The fee is doubled when work starts before the permit is pulled. Contractors working in the city carry a $35 annual building contractor license backed by a $20,000 bond or a $300,000 general liability policy. Those are city fees, not our price.
Most barns around Bowie are outside the city. Montague County's own pages cover septic (OSSF) permits through the county sewage inspector at 940-531-2179, and a floodplain development permit for building in a mapped flood zone. We didn't find a county building permit for barns posted there, so we confirm what applies to your property before we order panels.
Horse barns near the lake
Horse barns around Lake Amon G. Carter have two problems at once. They sit in the open where the wind hits hardest, as the 2022 and 2025 tornadoes showed, and the animals put moisture into the air that condenses on bare steel. When we re-roof a horse barn, we tighten the fastener pattern at the eaves, rakes and ridge and plan a vapor barrier or insulation under the panels with ventilation that suits the stall row, so the roof stays on and stays dry underneath.
New barns, built by our own crews
We don't only roof barns, we build them. For a new barn, pole barn, horse barn, shop or ag building, we can bring in an architect to spec the project, or build to the specs and plans you already have. Our own crews do the work from start to finish, and the roof can go on in a color that matches the house and the other buildings so the property looks like one place.
Details that decide whether a barn roof lasts
- Condensation control if the barn is enclosed, stores hay, houses animals or has any conditioned space. A vapor barrier or insulation under the panels and ventilation that suits the use keep it from "raining" inside. See condensation control under metal.
- Ridge and eave closures that fit the panel profile, so wind-driven rain, birds and wasps stay out.
- Flashing where buildings meet: lean-tos, porches, a shop wall or a stall row added later.
- Gutters and drainage where water would otherwise sheet onto a pad, an arena entry or a doorway. See gutters.
- Skylight panels replaced with the roof, because old clear panels turn brittle and crack long before the steel wears out.
- Color match across the house, barn and shop.
How a barn roof job runs with us
- Inspection and free digital photo report: panels, fasteners, trim, purlins and framing, with measurements. You see what we see.
- Written options: re-screw, re-panel or re-roof, with the panel, gauge, color, trim and fastener plan spelled out.
- Paperwork: we check whether your barn is inside city limits or on county land, then file what applies.
- Panels formed for your building on our own roll formers, cut to the length of each roof plane so long runs don't need mid-slope laps.
- Install by our own crew, with the edges, ridge and penetrations detailed for wind.
- Clean-up and walk-through: a magnet sweep for screws and scrap, so nothing ends up in a hoof or a tire, and your warranty in writing.
Storm damage and insurance on barns
Hail dents and punctures panels and cracks old washers, and wind lifts edges and tears trim. Whether a barn is covered, and for how much, depends on your policy: some cover farm and ranch buildings fully, some cover them for less, and some treat cosmetic dents differently from leaks. Our photo report separates storm damage from age and rust, which is what an adjuster needs to see. If you file an insurance claim, we document the damage and meet your adjuster on the roof. Texas law requires you to pay your deductible, and a contractor may not waive, absorb or rebate it. We never will. In Texas you generally have 1 year from the date of loss to file; check your policy.
Who roofs and builds barns in Bowie?
Snow Roofing & Exteriors does. Here are the facts you can check before you call anyone:
- 75 years as a family roofing business, and 30 years in the business for owner Blake Snow, who is still on the roofs.
- Over $80 million in completed roofing projects, from small repairs to multi-million-dollar jobs.
- 5.0 stars on Google at all three offices: Bridgeport, Decatur and Rhome.
- Our own roll formers for standing seam and R-panel, in 24 or 26 gauge, with metal lead times that are typically 1 to 2 weeks.
- Our own crew, working about 31 road miles (roughly 43 minutes) from Bowie out of our Bridgeport office.
- Snow Roofing & Exteriors is BBB A+ rated.
Photos
The barn image at the top is an illustration. The photos below are real metal roofs our crews installed on houses, shown so you can see our panel, trim and seam work up close. We don't have barn job photos from Bowie on file, so we don't show any. We never show a street or address.
We're certified with GAF, CertainTeed, Owens Corning, Atlas, Johns Manville, Carlisle, Tropical Roofing Products, Mule-Hide and Enviroshake, and many other roof manufacturers. More nearby: barn roofing in Chico, barn roofing in Bridgeport, barn roofing in Alvord, barndominium, shop and ag roofs and our Bowie roofing page.
Product names, ratings and features are as published by the manufacturer and can change. We confirm the current rating and warranty of the exact product before we order it.
Residential warranty: a workmanship warranty from 10 years up to lifetime, depending on the job, with manufacturer warranties up to lifetime. Manufacturer coverage depends on the product and brand, and on the project qualifying for that manufacturer's program. We put the exact warranty for your roof in writing.
Certified, with 30 years installing every major roofing brand, a family roofing business going back 75 years, and over $80 million in completed roofing projects. 5.0 stars on Google at all three of our offices.
Request a free inspection or call (817) 733-9228. Small repairs are welcome too.
