Outdoor kitchens in Southlake
Southlake has about 31,175 residents (2025 Census estimate), and many families choose it for Carroll ISD and stay for decades. Lots run from subdivision lots with a pool to one-acre-plus estate lots in the SF-1A district, and many houses are brick or stone under tile, slate, shake-look or architectural shingle roofs. That means an outdoor kitchen or pool house here has to look like it was built with a house that already set a high bar, and it has to clear the city's accessory rules and, often, an HOA.
Who builds outdoor kitchens in Southlake?
Snow Roofing & Exteriors does. Here are the facts you can check before you call anyone:
- 75 years as a family roofing and exterior business, and 30 years in the trade for owner Blake Snow.
- 5.0 stars on Google at all three offices: Bridgeport, Decatur and Rhome.
- Snow Roofing & Exteriors is BBB A+ rated, fully insured, with references available on request.
- Our own crews, who frame, roof, side, trim and finish outdoor kitchens and covers from start to finish.
- One company for the whole outside of the house: roofs, gutters, siding, windows, soffit and fascia, paint, and outdoor living.
- A workmanship warranty from 10 years up to lifetime, depending on the job, in writing.
Four ways to put a roof over an outdoor kitchen
Most Southlake outdoor kitchens end up as one of these. Which one fits depends on the back of the house, where the sun sets, how close the pool or the fence line is, and what the city allows on your lot.
| Layout | Good for | What to watch |
|---|---|---|
| Attached cover, tied into the house roof | Short walk from the kitchen door, one continuous roofline | The tie-in is the most common leak spot on any patio roof, and attaching can change how the city treats the structure |
| Freestanding pavilion | Putting the grill where the view, the pool or the shade is best | Footings, wind bracing and setbacks from the property lines |
| Cover over an existing island | Owners who already have counters and a grill out in the sun | Whether the island can stay where it is, and how smoke will clear |
| Kitchen built into a pool house | Big backyards, entertaining, a bath and storage under one roof | Plumbing to the sewer, pool setbacks and, for enclosed buildings, wall material rules |
We plan the cover and the kitchen together, so the posts land where the counters need them, the vent hood has a clear path, and the roof drains away from the cooking area and the pool deck.
City of Southlake permits for outdoor kitchens and covers
Southlake treats an outdoor kitchen as its own project. Its guidelines require a separate permit for outdoor kitchens, fireplaces and living areas that aren't part of the main house. A cover attached to the house is permitted as a Residential Addition, whatever its size. A freestanding cover or pavilion over 120 square feet is permitted as a Residential Accessory Building. If you're also building a pool, the city's pool guidelines let a grill or a kitchen with a bar sink, a gas-only fire pit or a fireplace ride on the pool permit, and an existing covered patio can get a grill or outdoor kitchen that way, but a cover over 120 square feet or attached to the house still needs its own permit.
The city’s February 2026 guidelines list what Southlake wants with the application:
- A plot plan showing the new structure and its distance to every property line.
- Foundation, footing or pier plans sealed by a Texas engineer, with a cover letter that references the current code and the soil report.
- Engineered framing and roof plans with the attachment details, an elevation, and electrical, plumbing and gas plans as needed.
- A form survey on every accessory structure and addition, uploaded to the permit and inspected at least 48 hours before the foundation inspection. With no slab, the survey is taken at the piers or posts.
- A Tree Protection Permit first where the lot has a tree conservation or preservation area.
The general contractor has to be registered with the city ($100), and the subcontractors listed on the permit must be registered too. Unconditioned accessory buildings are permitted at $50 plus $0.50 per square foot, and the minimum fee for any permit is $100. Those are city fees, not our price. Southlake runs on the 2021 International Residential Code with local amendments. HOA rules are a private agreement the city doesn't enforce, except that projects in Carillon need the Carillon HOA's approval stamp before the permit is submitted.
Where it can go on a Southlake lot
Southlake's zoning ordinance (Ordinance 480, Section 34) sets the placement rules:
- Outdoor kitchens go in the side or rear yard, never forward of the house. Outdoor fireplaces can go in the side, rear or front yard, and permanent fire pits stay at least 10 feet from combustible structures, as approved by the Fire Marshal.
- An accessory building on a permanent foundation sits at least 10 feet from a rear property line, or 5 feet if it has no permanent foundation, unless the district sets something different. Other structures taller than 8 feet stay at least 10 feet from the property line.
- Accessory buildings are limited to one story and 14 feet, and none can sit forward of the house.
- On SF-1A estate lots, all roofed accessory structures together are capped at 3 percent of the lot area or 4,000 square feet. One that's 500 square feet or larger has to meet the main house's setbacks (40 feet front and rear, 20 feet side), can go up to 20 feet tall, and, if it's masonry, has to match the house's masonry with the same type of roof as the house.
When a cover won't fit the setbacks, the Zoning Board of Adjustment can grant a special exception to reduce them. A 2023 case asked for 8 feet instead of 10 for a pergola over an outdoor kitchen. We'd rather design inside the rules, but we'll tell you up front if your lot needs that hearing.
Matching a Southlake roof
The cover is the part of an outdoor kitchen everyone sees from the pool and the back windows, so it should look like it came with the house. On a tile or slate house, we match the main roof when the cover's pitch and framing can carry it, or use standing seam in a color pulled from the tile or slate when the cover is too flat for it. On shake-look or architectural shingle houses, matching shingles work on a cover with enough pitch. Stone-wrapped columns that match the house's masonry, a stained tongue-and-groove ceiling and a gutter line that ties into the house's downspouts finish it. See patio covers that match tile with standing seam.
The roof is what has to last
An outdoor kitchen cover is a real roof that happens to have no walls. It gets the same hail and wind as your house, plus heat from the grill underneath. What we put on it:
- Standing seam metal, which we form on our own roll formers in 24 or 26 gauge. It handles the low pitch most covers have, sheds oak leaves, and looks right next to brick and stone. Metal lead time is typically 1 to 2 weeks. See standing seam.
- Shingles matched to the house, including impact-rated shingles, where the cover has enough pitch.
- Tile, slate or Enviroshake tie-ins on homes with those roofs. We match the main roof when the pitch and framing allow, or pair it with standing seam in a color pulled from the house. See outdoor kitchen roofs that tie into tile or slate.
- Gutters and downspouts sized so a summer downpour doesn't sheet onto the counters or wash out a flower bed. See gutters.
Where the new roof meets the house, we flash it into the wall or under the existing roofing. That joint should never depend on caulk.
Smoke, heat, gas and power
A covered grill needs somewhere for the smoke and heat to go. We plan the ceiling height, the vent hood and the clearances to the grill maker's instructions before framing starts, and we keep combustible trim away from the heat. Gas lines, electrical circuits for lights, fans and outlets, and any sink plumbing are done by the right trade under their own permits, and we schedule that rough-in so nothing has to be torn back open later. Natural gas or propane, a built-in refrigerator, an ice maker or a pizza oven all change what goes into the plan, so we ask about appliances first.
Hail around Southlake
NOAA's Storm Events Database lists 45 reports of hail 1.75 inches (golf-ball size) or larger within about 10 miles of Southlake from 2016 through the September 2026 update. The biggest came on June 11, 2023: 4-inch hail near Grapevine Reservoir, about five and a half miles away, and 4.25-inch hail near Bartonville. On April 28, 2021, 3-inch hail fell in Keller about five miles west, and on May 27, 2024 2.75-inch hail hit Bedford, about five and a half miles south. The Storm Prediction Center logged 1-inch hail along Hwy 114 in Grapevine on June 2, 2026.
A cover or pool house gets the same hail as the main roof. We build it with the same underlayment, flashing and edge metal as a house roof, and standing seam won't crack or lose granules the way shingles do, though very large hail can dent any metal.
How an outdoor kitchen job runs with us
- Site visit. We look at the back of the house, the roofline, the yard and the pool, and talk about how you cook and entertain.
- Design. We can bring in an architect to spec a new build, or build to plans you already have.
- Written scope. Structure, roof material and color, gutters, appliances, finishes and every flashing detail, with no surprises later.
- Approvals. Your HOA's approval if you have one, then the permit with the City of Southlake. We prepare the drawings and the site plan.
- Build. Our own crews build it from start to finish. The trades for gas, power and plumbing are scheduled around the framing.
- Inspections and walk-through. We call for the inspections, walk the finished kitchen with you, and give you the workmanship warranty in writing.
More for Southlake homeowners
Planning the whole backyard? See pool houses in Southlake and our pergolas and patio covers. For the house itself: metal roofing in Southlake, standing seam, tile roofing, slate roofing and Enviroshake.
We're certified with GAF, CertainTeed, Owens Corning, Atlas, Johns Manville, Carlisle, Tropical Roofing Products, Mule-Hide and Enviroshake, and many other roof manufacturers.
Residential warranty: a workmanship warranty from 10 years up to lifetime, depending on the job, with manufacturer warranties up to lifetime. Manufacturer coverage depends on the product and brand, and on the project qualifying for that manufacturer's program. We put the exact warranty for your roof in writing.
Certified, with 30 years installing every major roofing brand, a family roofing business going back 75 years, and over $80 million in completed roofing projects. 5.0 stars on Google at all three of our offices.
Request a free inspection or call (817) 733-9228. Small repairs are welcome too.
