Offices in Bridgeport · Decatur · Rhome · Class 3+ impact-rated shingles on every roof Call (817) 733-9228
Snow Roofing & Exteriors logo

Free Roof Replacement Estimate

📞 Call (817) 733-9228
Roanoke, TX · Standing seam metal

Standing Seam Metal Roofing in Roanoke, TX

Snow Roofing & Exteriors installs 24- and 26-gauge standing seam on Roanoke homes, shops and small commercial buildings. We run our own roll formers on the jobsite. Our Rhome office is about 15 road miles (roughly 23 minutes) away, so Roanoke is one of the closest DFW towns we serve. Call (817) 733-9228.

Roanoke's mix of roofs

Roanoke sits at U.S. 377 and State Highway 114, about two miles south of Grapevine Lake, and Census estimates show it growing from 9,671 residents in 2020 to about 10,931 in 2025. Its roofs run from older houses and storefronts around Oak Street downtown to subdivisions built in the last two decades and shops and outbuildings on the edges of town near the Alliance corridor. Standing seam fits each of those a little differently:

BuildingWhat we usually recommend
Newer subdivision homesFull standing seam in a muted color, or accent panels over porches and bays where an HOA prefers shingle main roofs
Older homes near downtownStanding seam over a new deck where an old roof has been layered or patched too many times
Storefront canopies and mansardsStanding seam faces with a low-slope membrane behind the parapet (commercial roofing in Roanoke)
Shops, barns and barndominiumsStanding seam, or R-panel / PBR where budget leads, with condensation control under living space

Why we form panels ourselves

We own our roll formers and bring them to the job. Each panel is formed to the exact length of its roof plane, so long runs go on without end laps, and if a panel gets damaged we form another on the spot instead of waiting days on a supplier. We use 24 or 26 gauge on homes and skip 29 gauge (why). Most steep roofs get snap-lock panels; low pitches get mechanically seamed panels. See panels roll-formed to length.

A real standing seam job close by

We installed standing seam on a brick ranch home near Rhome. That house is near our office, not in Roanoke, but it's the same kind of work: tear-off, deck check, synthetic underlayment, new flashing at every wall and pipe, and hidden fasteners under the seam.

Hail around Roanoke

NOAA's Storm Events Database lists more than 50 reports of hail 1.75 inches (golf-ball size) or larger within about 10 miles of Roanoke from 2016 through the September 2026 update. The largest was 4.25-inch hail near Bartonville on June 11, 2023, and on May 27, 2024 2-inch hail was reported at the Roanoke-area airport, about a mile from town. The Storm Prediction Center's 2026 reports include 1-inch hail 3 miles northwest of Keller and 1.5-inch hail 2 miles southeast of Haslet on August 26, 2026 and 1-inch hail just east-northeast of Keller on September 21, 2026. Standing seam usually keeps shedding water after storms that ruin shingles, but very large hail can dent it; we never call a roof hail-proof. Read metal roofs and hail: what to expect. If you file an insurance claim, we document the damage and meet your adjuster on the roof. Texas law requires you to pay your deductible, and a contractor may not waive, absorb or rebate it. We never will.

City of Roanoke permits

The City of Roanoke requires a roofing permit for a roof replacement, and contractors must be registered with the city. The city's roofing permit form says photo documentation — ground-level photos of the roof, vent terminations and attic vent clearances — may be accepted for the final inspection. We file the permit and handle the inspection.

We're certified with GAF, CertainTeed, Owens Corning, Atlas, Johns Manville, Carlisle, Tropical Roofing Products, Mule-Hide and Enviroshake. More on Roanoke: our Roanoke roofing page, standing seam in Trophy Club, standing seam in Argyle and standing seam in Westlake.

Residential warranty: a workmanship warranty from 10 years up to lifetime, depending on the job, with manufacturer warranties up to lifetime. Manufacturer coverage depends on the product and brand, and on the project qualifying for that manufacturer's program. We put the exact warranty for your roof in writing.

Certified, with 30 years installing every major roofing brand, a family roofing business going back 75 years, and over $80 million in completed roofing projects. 5.0 stars on Google at all three of our offices.

Request a free inspection or call (817) 733-9228. Small repairs are welcome too.

Our work: real projects

Real Snow Roofing & Exteriors jobs, photographed in CompanyCam. We name the area, never the address.

Frequently asked questions

Do you install standing seam metal roofs in Roanoke?

Yes. We install 24- and 26-gauge standing seam on Roanoke homes, shops and small commercial buildings, formed on site with our own roll formers.

How far is your office from Roanoke?

Our Rhome office is about 15 road miles from Roanoke, roughly a 23-minute drive.

Do I need a permit for a metal roof in Roanoke?

Yes. The City of Roanoke requires a roofing permit for roof replacement from a contractor registered with the city. We handle the filing and the inspection.

Can you roof my house and my shop with matching metal?

Yes. We can run the same panel and color across the house and shop, or use R-panel on the shop where budget matters more than looks.

Has there been large hail near Roanoke?

Yes. NOAA lists more than 50 reports of hail 1.75 inches or larger within about 10 miles from 2016 through the September 2026 update, including 2-inch hail at the Roanoke-area airport on May 27, 2024.

Get a free roof inspection

We get on the roof, photograph what we find, and tell you plainly whether you need a repair or a replacement.

Free Roof Replacement Estimate

📞 Call (817) 733-9228

Certified with GAF, CertainTeed, Owens Corning, Atlas, Johns Manville, Carlisle, Tropical Roofing Products, Mule-Hide and Enviroshake

Atlas Roofing certified contractor
📞 (817) 733-9228